Will this work at all?

[Pyotr]

Hey folks,
I have a H card bootloader with a 2313 chip on it. Can this be used to emulate dish?Does it need to have a iso attached?Thanks

[BiggerBear]

Can you flash the Atmel2313?. Some of those Bootloaders had Chips soldered to the board. I am not sure if you can flash those while on the Bootloader. If yours has the removeable chip you can flash it with an unlooper(if you have one)or you can build the simple atmel programmer for a few bucks. Look around on these sites, because I have just seen a Thread about converting Bootloaders.
Try dsshelper -- maestra and kichinchicken.org

[rubberman]

yeap thats what i did. I removed the atmel and programmed it in my unlooper. Since i we wont be using the bootloader might as well starting using those parts.

[Pyotr]

Can you flash the Atmel2313?. Some of those Bootloaders had Chips soldered to the board. I am not sure if you can flash those while on the Bootloader. If yours has the removeable chip you can flash it with an unlooper(if you have one)or you can build the simple atmel programmer for a few bucks. Look around on these sites, because I have just seen a Thread about converting Bootloaders.
Try dsshelper -- maestra and kichinchicken.org

Yup.The atmel is removable.As a matter of fact I took it ot of the socket already. I have an X-Nexus dual ISO-HU loader.What flash do I use.

[BiggerBear]

If your are going to set it up as a one chip emu go to dsshelper and read the STICKY about the one chip emu. There are some flashes in the Thread. Or you can find the flash maker program.