direct tv phase111 dish for dishnet

[nowisleep]

I have a converted bev3100 to dishnet. I got a good deal on a dtv phase111 (KTI) dish-3lnb's. Can I use this dish to recieve 110&119-dishnet and do the supplied switches work or do I have purchase an sw21 to make this work? Also anybody know where I can find the schematics for the above dish? Thanks in advance! One more question, there are 4 connections on the rear of the lnb's . Which ones do I use to get 110, 119 and how do I hook up the sw21 switch. It's a california amplifier made (kti) dish, do I have to make any modifications to the rear switches(they are sealed)?Any schematics out there? Thanks.

[Rax]

I have a converted bev3100 to dishnet. I got a good deal on a dtv phase111 (KTI) dish-3lnb's. Can I use this dish to recieve 110&119-dishnet and do the supplied switches work or do I have purchase an sw21 to make this work? Also anybody know where I can find the schematics for the above dish? Thanks in advance! One more question, there are 4 connections on the rear of the lnb's . Which ones do I use to get 110, 119 and how do I hook up the sw21 switch. It's a california amplifier made (kti) dish, do I have to make any modifications to the rear switches(they are sealed)?Any schematics out there? Thanks.

Here ya go... There was a sticky w/ this mod here , but has been removed. :)
Note: This setup does work.. I created this mod.

[nowisleep]

Here ya go... There was a sticky w/ this mod here , but has been removed. :)
Note: This setup does work.. I created this mod.
Thanks i will try it

[Rax]

If you have any ?'s send me a pm

[nowisleep]

If you have any ?'s send me a pm
I'm still a little confused. Is there any way I could take apart the sealed switch area and bypass the internal switch and use the existing lnb's to recieve dishnet and then i could put a sw21 to recieve 110,119?Thanks for all your help; I'm very new at this.