eddiemiller
12-20-2004, 08:21 AM
Okay I've got my 508 board out of the box and ready to do the Vid Mode , however I have ran into a slight problem , the Pic of the 50X in the Vid Mode Instruction where wire "A" goes is a litte different than mine , I don't have a good enough camera for the pics of mine to be worth shit ( its al blury using my camera Phone ) So I just did some editing of the orginal one to what mine looks like , So IF someone who has done one with this type board before will let me know if thats the correct spot ( its labeled in my pic ) where aire "A" goes on my board , I would appreciate it , just a note the spot I am talking about is right next to R325 on my board Also , I have the spot for R331 but there is no resistor there ( Its also In a different Location) I am uploading both pics ( The editted one that is what my board lloks like & the One in the 4 wire Vid Mode Instructions
Also I have 2 more questions , I know it does'nt say it in the instructions but seems like a rember reading awhile back in this forum about someone saying you should use a resistor in between the switch & the 12v wire , Is this true ? If so what kind ? Last Where on the DPDT switch that I'm using for the Vid mode should I hook the 2 wires coming from OJ1 , so that when the vid mode is turn on to write it is also on ( If I were looking at the Pic of the Switch in the Vid mode Instructions where do I Put those 2 wires?)
Also I have 2 more questions , I know it does'nt say it in the instructions but seems like a rember reading awhile back in this forum about someone saying you should use a resistor in between the switch & the 12v wire , Is this true ? If so what kind ? Last Where on the DPDT switch that I'm using for the Vid mode should I hook the 2 wires coming from OJ1 , so that when the vid mode is turn on to write it is also on ( If I were looking at the Pic of the Switch in the Vid mode Instructions where do I Put those 2 wires?)