Dp 301-013

[hawk25]

I just recently got my first ever Dp301-013 and I already have a Dp301-010 which i havent tried to use with any type of cards yet. My question is does any of these IRD's work with a ROm 3 card. I tried to use it with my Dp301-13 it kept saying its not meant to work with this reciever i tried the same card with a 3700 works just fine.no problems.. DO i need to get a rom 10 or Atmega to use it both of my IRD's..


Thanks

Hawk25

[skinerd]

The -013 will prolly need vid modded to set 7FFFFFAC to 0000 to enable blue card use.
The -010 should noy be a problem.

[hawk25]

The -013 will prolly need vid modded to set 7FFFFFAC to 0000 to enable blue card use.
The -010 should noy be a problem.


I got it recently but it is not the new ones...it has a build config of DASA. I am going to try it with Rom 10 and see what it does but ...does it make a difference or period if its a 301-13 it will need a vid mod for me able to use Blue cards or Atmega..

Thanks for replying...

Hawk25

[skinerd]

DASA will require vid modded, if it has not already been done, jtag and read 7FFFFFAC and see what it is.

[hick1]

Read the ird with jkeys. Go into Flash Programing a read address 7FFFFFAC If this says 0000 then it is good to go with any blue card. If it says D500 and is a single tsop it will have to have a vid-mod done to change it. If it says 0000 and you are getting the nag check your box keys and such

[hawk25]

Read the ird with jkeys. Go into Flash Programing a read address 7FFFFFAC If this says 0000 then it is good to go with any blue card. If it says D500 and is a single tsop it will have to have a vid-mod done to change it. If it says 0000 and you are getting the nag check your box keys and such


I am so sorry i should have mentioned that it is a single TSOP and that i was able Jtag it and back up the TSOP and Epprom fine. however, i need to check the flash programming part before i do anything further...

Thanks guys for replying to it...

Hawk25