My made up P4 went down!!

[mdeven]

A couple of things come to mind here....
First a question.... What are you running on the card?
Second.... Make up another....
Mark

[mdeven]

Will it run with a P3 (HU) CAM?
Mark

[mdeven]

If it keeps working with a HU "bin", then the problem might be the P4 "bin".... Let's try loading a good donor file ("bin") into ExtremeHu, clean it and change the CAM.... Save this file as your new "bin".... Shut down EHU then restart it.... Open the "bin" you just saved.... Patch your 3M to it.... Boot the card, clean it and write the "bin" to it.... If you can't patch to the "bin", boot the card, clean it, write the "bin" and patch the 3M to it.... Either way, don't forget to shut the card down when you're done....
Your new cleaned "bin" will be at USW 0800 and DSW 0000.... When you insert your card, you'll have to wait for it to update....
If this doesn't work, then the 3M is most likely the problem....
Mark

[mdeven]

Didn't see that when I posted.... Must have been while I was writing that long winded thing.... Anyhow, I still say the same thing.... Thanks for pointing that out....
Mark