rom10 A23

[newbie1conobie]

I have a rom10, a23, and have modded my unlooper. I've read Crazy1_79 guide as well. Here's my problem....

when trying to get a good glitch voltage range, all I get is +++++++++, i never get any -----.

from the guide, I need to lower the resistance on the pot. I've taken it down to barely above the dreaded XX (reset), and still can't get any -----.


I will double check my connections from the mod, but if anyone else has any suggestions, I'm willing to listen.

[Cid6.7]

Adjust your pot to 2.2 then decrease the VCC settings in the script..
On some rom 10's I have the VCC High as low as 0F & limit to 00

[skinerd]

I just had 2 ROM 10s that were tough, a LOT of RESET-RESET etc using NewD9......reflashed unlooper with NewD8 and they both popped within minutes.......

[hart]

Can you take a moment and tell me about New D8 as i have a rom 10 at revA23
thanks in advance. where to get it.

[JT]

Can you take a moment and tell me about New D8 as i have a rom 10 at revA23
thanks in advance. where to get it.

newD8 is one of the flashes for rom10 unlocking using a modified HU loader/unlooper.

[Crazy1_79]

yes follow jt's advice and use a different flash, some cards just don't like certain flashes.

[hart]

I wonder if it makes eny diffrence but I fill I sould tell you what happend.
While I was doing data editor , after entering millis base and a patch I went in to
(IRDinfo(41) provider(58) DecryptKeeys(123) Prividerinfo(58) and changed provider
from 00 to 01 I wrotte all this to the card and could not install millis blocker.
Now I cannot clean the card and it shows provider 01 cannot get in to back door and
asks for a 32 character key.
It shows the 32 character key it uses that does not work.
In eny way it is at provider 01 revA23 and cannot clean.

[JT]

It sounds to me like you need to go to www.bellexpress.vu, click on the how-to's at the left, and read the PB how-to thoroughly. There is also a private blocker and related quick links tab at the top of this page.

[hart]

JT in short I locked my self out of this card at RA23 I need to know how to modifie an HU loader and software and instructions to fix it.
Dont send me to school for now thank you .

[Cid6.7]

What kind of loader?
Just type "your loader" mod in search

[newbie1conobie]

still no luck...thanks for the suggestions

[newbie1conobie]

finally got that sucker to pop...

I was retracing my mods...and my unlooper didn't have switches...

only 4 jumpers...

originally #2 was jumpered, and I cut that trace. I placed a jumper on #4, and ran vcc analyzer till i got a good mixture of 6F FF....

voltage range was 4D to 46....

ran powersync 5a with d8-rek flash over nite, and when I got up, it was open!!!!

now time to try an A24....is there a different flash or script I should use first?