Adjusting the POT setting on T911?

[jigger]

I have the T911 from ModChipit. I understand the 6 DIP switches for flashing, however there is another Black switch next to it. One setting is SW1 and the other is blank. I had trouble flashing it until I changed the black switch. I don't know what that switch is for can someone tell me? After successfully flashing it I tried directly to go to Winexp and run a script, but Winexplorer will not recognize the unlocker. I have the correct com port set, and have adjusted the settings from the Sticky posted in the forums. I did NOT adjust the POT setting. Would that ommission prevent Winexplorer from recognizing the unlocker?

[Cid6.7]

Hit the switch the other way & put 2&5 down to run a script...

[cablecowboy]

i have the same loader. I believe that switch is for flashing only. push it towards the power input when flashing and push it towards the dip switches when unlocking.

[cablecowboy]

jigger, when i went into winexplorer config and created loader 2 with the proper settings it didnt recoginize my loader either. Someone told me to use the unlooper that was already there and just change the settings to the ones listed in crazy1s how to post. Then it recognized my loader and popped my first card 5 mins later.

Hope this helps.

[thekiss777]

I have a modded T911 flashed it with the latest flash x and it programmed flash to flash it dip pins 1&5 on and switch towards power indicator line on programme went to full and said done run about a dozen different scripts oh yah i put switches back to 2&5 to unlock and put the power backtoward dip switches and no luck unlooping rom 3 Rev 383 these cards are almost impossible to unlock or unloop message says the following,
Opening of COM1 was successful
ATR String: 3F FF 95 00 FF 91 81 71 64 47 00 44 4E 41 53 50
30 30 33 20 52 65 76 33 38 33 F5
ROM Revision: 003
EEPROM Revision: Rev383
Logging into card
Checking for BackDoor
BackDoor appears to be closed, aborting
Error reading image from card
Closing of COM1 was successful

Any suggestions on how to unloop this card or to unlock it!!! Whatever I have tryed scripts to do either nothing my friend who is much more exp than i tryed for a week now i have been trying for two weeks!!! Any advise welcoming

[Cimba]

For a rom 3 you should be using newd6.exe program.

[playme1979]

try with dipswitches 2 and 4 down that was the key for me with my t911 and rom 3's

[thekiss777]

I have been using newd 6.exe in the past no luck but i will try changing to 2&4 maybe that will work at this point i.ll try anything thanks guys i do appreciate your advise Thanks again

[thekiss777]

I am currently using rom 3 unlocker 383 penga 69 unlocker hope for the best set dips 2 & 4 set to on all others off flashed with newd 6.exe