did i flashed wrong sector help!!!!

[haris5060]

I read this guide which said to use flash 1 on 501 ird toflash SA54 and i did and jsut now i found out this some other guide which says that for 501 one should use flash 2 SA SA52 or SA54 and SA60 <<< even this doesn't make sense is it saying erase SA54 & SA60 or just one sector SA52..
this guide is on this site but the other i used and i have alreasy flashed sa54 using flash1 tsop,,,...... what should I do if I did wrong flash should i go ahead flash the flash2 Sa54 and Sa60 and puit the IRD in streamm or what????
please help me

[ynot-try]

IF you trying to recover from an ECM then eraseing sa52 sa54 sa60 in flash 2 and restreaming without a card will work,
doing the above should bring your unit back to life even if you erased flash 1

[haris5060]

should I install lock now for tsop and than stream it without card and as soon as its done with stream i should put lock on right

Also i have this lock i dont know what version but it has these wires WE1, We0 Dq7,DQ4,Dq1,P3v3 pGv , gnd.....
any guide to put this lock .... because this lock did cam with a guide and where i bought it from they say they dont support it I bought it from DSS-Stuff.ca
\any help please

[ynot-try]

i dont have any locks on mine so i couldnt help you