best way to unlock a rom3

[mongoose123]

with a rom3 card what is the best unlooping unlocker script / program to use

i have a nexus and i havent been able to do it with anything

i just want to know if any1 can share any success stories with certain scripts

man 3rd day already on 1 card what a waiste of freakin time

[yelir1]

It will work when you get everything set right. I had the most sucsess with unlockrom3.xvb. Had to get the vcc set right for my loader , it glithed at a slightly higher setting than most run there's at mine I set to 68 high and 5B for low and the delay around 10AF. But like I said every loader vcc is differant. Don't give up, accuratly post what you are doing and you will get good help from here.

[Cid6.7]

take a look @ my rom3 guide..
If yah still need help I'm always here

[mongoose123]

this is my 4th day still no success

[mongoose123]

what is the minimun and the maximum VCC
i tryed from h01 to h99 and got nothing but XXXXXXXXXXXXXXXXXXXXXXXXXX with my orange nexus 911

[Cimba]

First off the orange Nexus is very different from one unit to the next. See the zip I posted with info about it in the thread " a little lost" by HillBilly in this glitching forum.
Have you read Cids rom 3 guide and Crazy's modded programmer sticky, in this forum ?
Try different delay settings.
What flash did you use and did it say it took the flash ?
What does reading it in Nagra tell you ?
What switch settings are you using to flash and run program ?
Did you set the new WinEx settings called Loader2 for using mods ?
Did you run VCC analyzer to get your optimal ranges ?
Sorry for asking what may seem insulting questions but without all the info it is hard for anyone here to give informed help.

[Cid6.7]

Is it the new Nexus Duo ..? No mod's needed ...everything is on the board..?
or the T911..?

[mongoose123]

its a ORANGE NEXUS from dishmonkey.com all mods are in the circuitry so no mods needed

[mongoose123]

What flash did you use and did it say it took the flash ?
NewD6
What does reading it in Nagra tell you ?
it reads the card but says the backdoor seems to be closed
i know the backdoor unlock code but it will not unlock
What switch settings are you using to flash and run program ?
1 and 6 to flash 2 and 5 to glitch also tryed 3 to glitch
Did you set the new WinEx settings called Loader2 for using mods ?
i tryed the normal unlooper setting and i tried
the setting in the readme file i downloaded on here
data baud=115200
reset baud=115200
parity =none
rec timout=1000
byte delay=100
reset delay=100
stopbits =1
byte convention= direct
flush echo bytes= no check
flush receive buffer= check

===========================
advanced tab

check device reset(no atr)
no check ignore receive timout
dtr= low
rts= high
toggle line =rts
Did you run VCC analyzer to get your optimal ranges ?
i tried from h01 to hFF and h01 to h99 i did not get anything high is 00 and peak is FF

[Cid6.7]

I got 1 of those Nexus Duo's It was faulty all I could do was flash it..every script I tried to run on it would error out...Sent'er back...

[mongoose123]

ok should i get another nexus or should i get a normal t9100

[Cid6.7]

I'd get the normal T911 & mod it..