little lost

[HILLBILLY]

hey all,
i have a nexus modded and i have it flashed with d9-9.
i'm not sure if the dips arew the same for all loaders, but i flashed it using 1 and 6. i go to use unlockallver2, and if i set the dips to 2 and 5, i get please insert card even though its in. if i leave the dips at 1 and 6, it runs. can't get this a23 to pop though. anyone seen this with the dips before?
thanks
hillbilly

[Cimba]

hey all,
i have a nexus modded and i have it flashed with d9-9.
i'm not sure if the dips arew the same for all loaders, but i flashed it using 1 and 6. i go to use unlockallver2, and if i set the dips to 2 and 5, i get please insert card even though its in. if i leave the dips at 1 and 6, it runs. can't get this a23 to pop though. anyone seen this with the dips before?
thanks
hillbilly

The nexus is notoriously different from one to the next by all reports.
I have gleaned some info about it as follows in the attachment.

[HILLBILLY]

thanks.
i will try the 3 dip. in 1and6 i wasn't getting the rx and tx settins either, so i'll give it a shot. '
thanks
hillbilly

[bama3416]

Hillbilly
Here is what worked for me. 1&6 to flash the Nexus. Put switch 2 down only to pop the card. This same setup has also been used by a couple buddies of mine also. Yet even another Pal used 2&3 down to pop his A23. Good Luck

[HILLBILLY]

ok, just so i'm clear. the proggy MUST show the tx info first? the reason i'm asking is like i said, 1and6 will run, BUT the tx info is NOT there, so i am assuming that its not working right?!?
thanks again all
hillbilly

[HILLBILLY]

thanks.
i will try the 3 dip. in 1and6 i wasn't getting the rx and tx settins either, so i'll give it a shot. '
thanks
hillbilly
using dip 3 with unlockallver2 did the trick in little over an hour.
my first card pop, and it feels great! thanks to all for the help.
hillbilly

[Quincy]

Hi Hillbilly i got same issues with my rom3 with nexus orange moded when i put dip 3 it doesnt ask to insert card it tries to unlock but it keeps running it has been running for a few hours now with out popping, i was wondering if you could help me out please with advise. also climba can u post taht attachment again please
thanks

[Quincy]

I got the rom3s unlocked i used dip3 and PowersyncUnlockALLver2b.zip and it worked in bout 10 minutes,

[rykrishell]

I got the rom3s unlocked i used dip3 and Power

syncUnlockALLver2b.zip and it worked in bout 10 minutes,

Why are you popping rom 3 cards i though they are no good for n2 , not enough room on the card :rolleyes:

[Quincy]

yeah i know i just got my unlooper and wanted to test it before i try them on rom10s and 102s