Receiver resets itself about once ever 85 Minutes

[Duffy75]

Not exactly sure what to do here.

Is this happening because of an ECM, or do i need to do an update or something?

I have a digital lock on a 301.010 .

Do you guys think it is because of the script on my card, or am i needing the receiver to update?

I pulled my card out of the receiver, turned the receiver off (but left it plugged in) and so far nothing has happened (been about 15 minutes).


I couldn't find an option in the menu where i could verify that the receiver is set to receive updates "without my permission".


Any suggestions?

[Crazy1_79]

it shouldn't try to take a update if the receiver is turned on, but the update option is under "sytem updgrades" in the menu, sounds like ecm's to me. Which blocker are you using? try changing cam ID, using a different blocker, is you blocker up to date?

[fucknutts]

it shouldn't try to take a update if the receiver is turned on, but the update option is under "sytem updgrades" in the menu, sounds like ecm's to me. Which blocker are you using? try changing cam ID, using a different blocker, is you blocker up to date?How.where do we get an up to date blocker??

[smilingjack]

CURRENT iIRD SOFTWARE IS P-229 FOR THE 301.10

[general]

card problm. i ran into that too .

1.has the cam id running good till this point?
2.try changing it ,as far as i know all blockers are fine
3.if it does it again,write a clean bin back to card
4.last , if it gets hit agin try reflashing reciver

it will run you in circles just narrow it down if reciver faults,most of
the time it is in card.

[general]

updated already