Proper Tsop

[Captonenut]

Hi all, I was looking for a Tsop with the build config of CAPD and was unable to see one in the bank. Only one I can see are CAPA. What other Tsop can I use for the CAPS Build config?

Thanks all for your Help

[LuckLarry]

CAPA and CAPD are interchangeable, as long as its the correct privider for your needs.

[smilingjack]

Best is all 4 same
Next best is first 3 same
First 2 usually OK

[Captonenut]

Thx for the infoGuys, although I am now having a hard time uploading new tsop to reciever. :)

[smilingjack]

ERASE 3 TIMES, immediatley upload the new one without stopping.
If it has 2 bins do bin 2 first, then bin 1, then virgin EPROM

[t160hq]

Sounds like a 2700 flash.

When flashing any 512K size receiver I always ground pin 1 of the JTAG port on the receiver. For me at least this seems to take care of any flash problems. It puts the reveicer in boot from link mode. In this mode dosen't matter what you throw at it or what type of JTAG reader/writer you use. It will write with no problems.

When grounding pin one.

Unplug receiver.
Close Jkeys if running.
Ground pin 1 of the JTAG port of the receiver.
All other JTAG connections as usual.
Plug in receiver.
Fire up jkeys.
Erase and program as usual.


Usually only necessary for hard to write cases. For the most part the 2700 reads and writes no problem with a standard JTAG hookup.

t160hq