5900-bev convert to dish problem

[cuda1]

5900 converted to dish but have a incompatible card version problem message I checked flash 2 at 7fffffac at 0000 any other problems that I missed or can this receiver not use rom 3 or 10's any help would be appreciated THanx

[rambo41]

You are going to have to vid mod the ird to make it work on Dish....... :rolleyes:

[cuda1]

I was avoiding vid mod but I guess I am going to now Im going in`!!!!!!!!!!!!!! Thanks

[skinerd]

No, if 7FFFFFAC is 0000, no mod is needed.
Erase flash 1, it won't completely erase but that's ok, then erase SA52, 54, 60 and 61 in flash 2, stream it to a dish sat, without a card in.
Or erase flash 1 and 2, they won't completely erase, but again that's ok, then write flash 2 with a P223 dishnet flash "moved ird info". It will error out at about 99%, but that's ok too.

[cuda1]

I tried to make hard drive smaller 80 gig and 00 out and now i get hard drive error but receiver works. hard drive don't!! does it need to marry? write p80 to to marry?

[skinerd]

I tried to make <a style='text-decoration: none; border-bottom: 3px double;' href="hard%20drive" onmouseover="window.status='hard drive'; return true;" onmouseout="window.status=''; return true;">hard drive</a> smaller 80 gig and 00 out and now i get hard drive error but receiver works. hard drive don't!! does it need to marry? write p80 to to marry?

Yes, it needs to marry, p080 should do it.

[cuda1]

all working again thanks wrote p80 then after p223 all working with rom 10 now.

[PatSkY]

I have 5900 and when I tryed to change IRD# and boxkey ( using jkeys flash 2 )
It error out at about 99%, when I put original Flash dump, It complete the flashing progress, can someone help me ?

[skinerd]

The original flash writes 100% cause it is not attempting to modify the locked sector, so it appears to write 100%, actually it isn't writing in locked sector.
You will need to unlock the locked sector to write a change to it.
As long as 7FFFFFAC is 0000, there is no need to write to the locked sector, receiver number and boxkeys are stored outside of that sector. Just let it error at 99% and it should still work fine.

[PatSkY]

Ok, What I do is dump flash 1 and flash2, using Hex WorkShop, I changed the ird and boxkey in flash2 save the file, ground the pin1 of jtag, jump (with a switch) VR10 and R146 pin, erase the both flash three time each, program the flash 2, first Error msg appear "The flash is not completly blank do you want to continue?" I click yes, And the other error appear at 99%, when I rebbot the IRD, open JKEYS and nothing change in IRD and BOXKEY area :(, what im doing wrong !!??

[skinerd]

ground pin 1, in a 5900????? won't do any good and might be harmful. Find and jump OJ1 connections. Maybe that is what you mean by VR10 and R146, not sure, OJ1 is inside a white rectanglular box, the OJ1 marking points to it.
Are you sure you are writing the modified flash to flash 2?

[PatSkY]

Ok, you need to write virgin tsop before you can put your Tsop ?