CAM ID & ZKT

[mdeven]

None of it's possible, sorry to say....
Mark

[Pyotr]

Before I knew how to program Hu cards, I had a couple of Virgin Cards never programmed, direct from DirecTV. The person I learned to program from didn't tell me the value of these cards and how I should have saved an image of the card before doing anything. I have written bins, hexes and activations on these cards and unlooped them on many occasions since. Well that was the past, but I am sure the original CAM IDs to these cards have never been blacklisted. Is there a way to reprogram the CAM ID number manually back into the card using the information on the back of the card?

I've been told that it is possible, however I must have atleast the Primary ZKT intact. How can I check to see if the ZKTs match the CAM ID? Also, if they don't match is there a program / guide to recreating the ZKTs? If all is possible, how would I manually put (program) all of this info into my card? And finally, if I were successful to that level, how to prevent my card from being blacklisted?

I know these are a lot of questions. Thanks in advance.

There's a remote possibilty if you used Extreme HU when you first read the cards. EXhu saves a bin by default when reading.If you never cleaned out the BIN directory,they are still there. But,it might not be possible to update those bins through the stream. Good Luck