dishpro channels list

[danielk]

Hello I have a Pansat 2700a and using it with dish 500 ant.
I have loaded the bin file and channels list but no go. Have
good signal on both 110 119 birds with good qualty. But
cant get any channels. I have been reading and I think I
need a channels list for dishpro. Also doing a scan it finds
alot of channels with good quality but they all say Scrambled
or bad channel. Any help welcome...

Danielk

[fredy_el_angel@]

make sure you got the lates bin with autoroll if you do then try to turn the key on and off
i think you may have the wron bin.

[freedss101now]

what bin are you using? and what channel list are you using? also, is your setup correct, like are you using a diseqc, lnb type, make sure those are ok. Sometimes you have set 110 on diseqc 1, and you change it to diseqc2, and still get signal quality from another sat that uses that.

If all settings are correct and no problem with bin, i recommend using bin 110 since it's the best and most stable, i think, although there is a newer bin, delete all channels and do a blind scan to see if it's the channel list that causes the problem. post back if you still have a problem.

[danielk]

Thanks guys for the post, Im been using bin x-87bl_050315_101
and channel list Working5-legacy-2700. I keep reading that sense
Im using the dishpro I nees to load something different because of
the dishpro lnb's. In ant. setup I dont use any swichs because its
builtin to the dual dishpro lnb and I just running 1 line to fta.

Thanks alot

[danielk]

What key that your asking about, and where is it at?

[bogus]

You need the 111 bin and a DP list. here they are. bogus