Opening of COM1 failed [Archive]

StreetStock

07-24-2005, 04:13 AM

Well I recently got ahold of a rom3 card and milli's private blocker. I'm using a SCM SCR111 ISO programmer with NE 4.1.

My problem is that nagraedit can't open the port my programmer is on. Which is COM1. I get an Opening of COM1 failed error. When I run the basic utility that came with the programmer, it reads the card fine and says its inserted. (see attachment).

Anyone have any luck with this programmer or am I SOL. :(

Any help will be greatly appreciated!

StreetStock

07-27-2005, 10:50 AM

Well to answer my own question. My reader is not phoenix compatible. But I did find a few progs that might help me use the reader I have. The following websites are hxxp://http://www.smartcache.net/ and hxxp://http://www.ttfn.net/ (DELETE THE HXXP). Anyone use "converter" progs like these b4? ANY HELP would be greatly appreciated. :)