Dishnet Channel 101

[HUGHIE]

I have had my reciever switched from Bell to Dishnet, I have programmed the ROM10 card and all I get is channel 101.

Can anyone help me with this?

[#40Fan]

What receiver and what firmware does it currently have on it?

[LuckLarry]

Start by checking your location i.d. in the sys info menu. Is it 0000001 by any chance?

[HUGHIE]

it shows

DP301
SOFTWARE: P241

R00 XXXX XXXX
S0X XXXX XXXX

DEVICE: UNKNOWN
REMOTE ADDRESS:1

[JCK7]

Check sys info
Location ID if 00000001

YOU NEED ERACE TSOP sa 8 line not full

[t160hq]

it shows

DP301
SOFTWARE: P241

R00 XXXX XXXX
S0X XXXX XXXX

DEVICE: UNKNOWN
REMOTE ADDRESS:1

The number you posted is a Bev Cam ID. You need a DN Cam ID. The S00... number.

On the system info screen hit the next icon at the bottom twice. That will put you on the third screen of sys information. (That would be highlight 'next' then press select. twice using the remote). Second entry will be Location ID: XXXXXXXX. If it's 00000001 you have been ecm'd and the receiver will need to be fixed by erasing SA3 in TSOP 1 and hooking up the receiver for a update.

Then we can find why it was hit. Most likely that Bev cam id or a too wide PPV tier or blocker that was applied to the cam.

t160hq

[HUGHIE]

Yep, i was hit. It shows 0000001.

is ther anything i can do?

I have another ROM10. Would i be taking a chance if i used it?

[JCK7]

YOU NEED ERACE TSOP sa 8 line not full

You need erase line sa3 or sa8 on rec

[t160hq]

Rom10 is fine. It's the receiver that is hit. If you have a JTAG you can erase a sector in the TSOP and restream to fix the hit. If you don't have a JTAG you will either have to build one, buy one, or do a Junkyard fix (not recommended by me but others swear by it).

For the JY fix a search will find the method for the 301-010 that you are looking for. Can't remember how off the top of my head.

Before jtaging or JY fixing the receiver. Reprogram the cam with just the top 180 and the latest blocker (If you don't have the best blocker from mili that is). A search for GCSB should find references to the latest free blocker. Also pick up Scammer2 (from the files section) for comming up with a camid.

t160hq

[mrplow1]

thanks I want to thank all of you for setting me up with the codes that i needed over the past year. I'm sorry to fined out that it is comming to a end. I sure hope that thing will get better. Thhanks Mr.Plow1 :cool: :cool: :)