coolsat 4000 plus

[morton]

I was geting bell channels but are now scrambeled, how do i get dish net?, 1 am o n 119 sat 7
Thanks for any help
Morton

[Crow 492]

Hi here the software for Coolsat , I have been test and working excelent

[morton]

Thank you. Can you tell me how i down load it to the receiver?
Thank you once again.
Morton

[Crow 492]

Loading your Coolsat....

--------------------------------------------------------------------------------

Downloading Firmware

Make sure STB is connected to the computer using Null cable RS 232. (or if using Pro, straight tru cable)

1. Turn STB power ON
2. Open STBTOOL.exe application icon
3. STBTOOL v1.5 screen appear. Firmware page and Download buttom will be selected which is preset
4. Browse and locate COOLSAT4000_100_20041208.stb and Open it
5. Click Auto Detect buttom to verify your computer COM port then click Exit
6. Click Connect then Start. It will take about 1 minute
DO not interupt until download is completed
7. Once you see Vision 1.00 detected click X on the top right

Downing Key

Make sure STB is connected to the computer using Null cable RS 232. (or if using Pro, straight tru cable)
1. Turn STB power ON
2. Open STBTOOL.exe application icon
3. STBTOOL v1.5 screen appear. Firmware page and Download buttom will be selected which is preset
4. Select Keys page and select Download buttom (this step not really necessary)
5. Browse and locate SoftCamAmerica.Key and Open it
5. Click Auto Detect buttom to verify your computer COM port then click Exit
7. Click Connect then Start. It will take about 10 seconds
DO not interupt until download is completed
8. Once you see Vision 1.00 detected click X on the top right

Downing Channels

Make sure STB is connected to the computer using Null cable RS 232.(or if using Pro, straight tru cable)

1. Turn STB power ON
2. Open STBTOOL.exe application icon
3. STBTOOL v1.5 screen appear. Firmware page and Download buttom will be selected which is preset
4. Select Channels page and select Download buttom
5. Browse and locate ch list and Open it (or any other channel list)
5. Click Auto Detect buttom to verify your computer COM port then click Exit
7. Click Connect then Start. It will take about 20 seconds
DO not interupt until download is completed
8. Once you see Vision 1.00 detected click X on the top right

Hook up STB to TV and wait for 4 to 10 minutes channels will show up.
Make sure you have the right Diseqc Setting ( Hardware and Software match )
STB are preset to 0000 password
__________________