005 on 128

[whitestuff]

Thanks in advance for ideas, I've got 2 3900's with atmega 128's. Using the same write for 3 months+ with no probs. Last week one 3900 had the 005 nag. Other 3900 was working(?) fine and still is. Put the good card in the 3900 with the nag, worked fine. Put the bad card in the other 3900, 005 nag there too. Okay so it's the one card. Ird's and box keys are the same on both 3900's, all 0's. Tried identical cam id's(and others), no luck. Tried reset, no luck. Let it stream for 24 hours, no luck. Reflashed card, checkswitch, deleted SA30, all with no luck. It does get 101 but 005 everywhere else. I've searched forums all over, seems like I'm not the only one with this problem, but haven't found an answer other than 3900's may be touchy with atmegas. What do you think?

[metwo]

005 is keys- they are not rolling with the program you put on that card- try getting the latest keys and put them on the card with one of the newer files- i use tcfd

[whitestuff]

THe write is working ok on the other 3900, but I am also putting in fresh keys as well when I write. I'm trying newer writes but it freezes when writing the eeprom to the card about a third in. By the way this is jeepers, which has always worked for me in the past, never had this dam 005 bitchofanag. I'll keep truckin, any other ideas?

[muleman]

check your pm

[whitestuff]

Metwo- Thanks for the help, it was the write I had been applying. Guess I figured since I knew it was a good write and using current keys it should work. You know, I have looked high and low on forums of about 5 other sites and nobody ever posts a clear cut answer. Hope this thread helps someone somewhere sometime. Thanks again!