Dish Nag Then IRD dead

[pimpin]

Question... was getting Serious problem error on a 300 using atmega128. This message would pop up every minute to minute and 30 seconds requiring the card to be removed and re inserted. Thought it might be that the card was not programed properly but when i reprogramed the card and inserted the ird went dead. I'm using a lock but was newly instaled and I'm not sure if the problem relates to that or if there is some thing else going on.

Regards

Pimpin

[smilingjack]

It's over dude, not much left and they are going fast, time to move on

[pimpin]

Fair enough but would obviously like to figure out what is going on. I have managed to get the IRD to turn back on... think it was getting ecm'd and the lock needed to be reset... ? maybe...? Not sure but unplugging the IRD and switching the lock off and back on again seemed to do the trick. I know with BEV if you programed the card with the wrong zip code you ran into some problems with ecm's and nag's etc. With TCFD you don't have the option of altering the zip code so I don't think this is the problem. I have two systems runing (one is a friends and both are obviously Dish). One is using plastic and is running fine, limited channels of course but other wise fine. The second using the 128 gets this nag problem every 60 - 90 seconds. Any ideas?