need help please

[furious]

here's what i did

1. bought a pansat 2700A
2. hooked it up to my dish 500
3. loaded X-87BL_050901_114_api with gtrom loader
4. under attena selected all the echo sats

thats where i'm stuck i want to view 110 and 119 what should i do . what settings should i select. under diseqc what does #1 #2 #3 #4. should i select 22khz should i select standard. i only get 300 channels and there all black 30% signal strenth.
can someone please break it down for me or show me where i can get this info.
i looked and looked. it sucks to be new. thanks guys

[baciboy]

here's what i did

1. bought a pansat 2700A
2. hooked it up to my dish 500
3. loaded X-87BL_050901_114_api with gtrom loader
4. under attena selected all the echo sats

thats where i'm stuck i want to view 110 and 119 what should i do . what settings should i select. under diseqc what does #1 #2 #3 #4. should i select 22khz should i select standard. i only get 300 channels and there all black 30% signal strenth.
can someone please break it down for me or show me where i can get this info.
i looked and looked. it sucks to be new. thanks guys
Ok I will give it a shot.

First....the numbers on the Diseq is what it represents on your system. So if a 110 is hooked up to #1 then on your Pansat move it to #1. If 119 is on #2 the move it to #2 on your Pansat etc.

Two...the 22khz is not vor north american systems, only for European. It should not make a diffrence on your system, I hope that helps.