110 satellite problem

[shastana]

I believe it is simple question for someone who knows, but for me is tough.
Please help. I have Fortec Lifetime Ultra and it is connected through switch
to dish500(110,119) and 18" dish(61.5). Now, I have installed it properly
(I believe so), I have signal more than 90% on each satellite. 119 and 61.5
are working good, but 110 is really headache for me. Almost on every channel
I have good signal but I get "The channel is scrambled or no signal".
Also I have sometimes freezing on international.
I'll appreciate any help.

[el6]

What switch are you using?
Are you using DishPro LNB ?

[shastana]

I use DigitSTAR 4x1 Diseqs switch and 20" Bell dish with 2 LNB

[shastana]

Any suggestion?

[calin]

Did you check the info in your receiver? I mean the DiSeQC switch settings for each sat?

[maroz28]

I have the same problem with 110 only. I have a fortec lifetime ultra with 18 inch dish (110 and 119). I have used 3 different desqc switches. 1.0, 1.3, and 2.0 mhz. I have also tried every single option on the menu with the desqc options (tone A, tone B, #1,....) I get any channel on 110 for about 10 seconds then it goes "no signal or bad channel). I have been reading all day and can't figure it out. I am using Ultra 281 bin. Any help would be apprieciated.