6000U Cutting a Jtag hole

[nomaam]

I would like to ask if someone could post the exact measurements on where to cut a jtag hole in a newly purchased Echostar 6000U model IRD. Thanks.

[fubr]

I do not have files handy or a ird to look but I have cut many. look for the 6000 jtag guide or a file called jtagallpads and it will show.
or
I have took a spong and got something on it like ink or cig ashes and placed it on the board with tape or glue then insert the board in the case and take board out then cut out the mark it makes on board.
dont use scotch tape use some esd tape or maskin tape or even electrical tape. bust a ink pen for the marking but dont get ti all over the place.

[nomaam]

Thanks Fubr, I figured I would have to do something like that. Just hoping for an easy answer. Take it easy..

[#40Fan]

I'll get you a good pic with measurements. This is looking at the bottom with the front side of the receiver towards you.

Red line is 3 5/8"

Blue line 1 5/8"

Green line is 7/16"

Yellow line is 1 11/16"

[nomaam]

That's great!! Exactly what I was hoping for. Now I just need to modify my jtag or find one made for a 6000.

Thanks again.. :)

[#40Fan]

Glad to help.