pantec and dish500 problem Help me please

[epstein1]

I have written numerous posts about testing with a Multistar Pansat ultra 2500...and Im still having so many problems with this system. I'm using a dish500 setup with two dishnetwork dual lnbs 119 and 110 and a DiseqC Switch (MultiStart MS-SM41 super mini 4in1 900-2400MHZ) the problem is I can not get both dish signal to be continuous on the receiver I do a blind scan on each seperate dish to get channel list done that and I plug in the switch to watch channels from both dishes and will only let me watch one sat or the other not both if 119 is coming through then the channels on 110 will be blacked out (scarmbling info or no signal) This is strange I have checked and rechecked wires ends ports on switch match the settings in antenna setup I have no clue as to what to do next nothing works. Any help would be appreciagted. Thanks in advance

[t160hq]

Did you try a blind scan on each sat with the discq switch hooked up and properly set up in the antenna setup.

Not sure about that model but switch setting and channel may be stored in memory when doing a blind scan.

Doing them individually then installing the switch may confuse the receiver since no switch settings were stored for the sat.

t160hq