Digiwave 7000

[riverman]

I am missing all the odd transponders on 110 & 119. I have changed cables and disesq switch and nothing I can do will get the odd transponders to show a signal.The even transponders work fine. Does anyone else have a similar problem or remedy.My signal strength is strong.

[DrRa]

what bin are you using

[riverman]

I am using this bin "digiw7000_hw130_v303_p240_0922_epg_n1_n2_"

[DrRa]

hmm how exactly strong is your signal and did you do a blind scan to pick up the channels

[Hopey007]

Had the same problem, perfect signal with dishnet receiver, ok with digiwave but missing tp's. Turned out to be the ground on one connecter. Try each dish direct with no switch.

Hopey007

[riverman]

very strong signal using 3' dishes.Tried hooking directly with no switch still not getting the odd transponders.I am wrong when I said I was not getting signal on odd transponders what is happening is they are not locking on and not going yellow in the signal bar.When I do a blind scan I get the channels on the even transponders only.I guess I have a bad receiver that is not changing voltage to get all transponders.Does anyone know what component might not be working?

[Hopey007]

I was getting signal on all tp's just not locked on all tp's. Take your receiver close as you can to the dish and use a short cable no switch, sat 119. You should only lock even tp's until you reach 10 then you should lock odd and even. If this doesn't work problem is either lnb or receiver.

settings

type fixed
sat echo119
lnb type normal
lnb freq 1 11250
lnb freq 2 11250
0/12v none
22kh tone none
diseqc none

hopey007

[riverman]

Thanks hadn't thought of that.Will wait till the rain stops.

[corcey24]

i had a similar problem when i first hooked up my digiwave 7000 it seems as soon as i loaded a channel list and did a scan that i got all the channels don't know if this will help or not

[riverman]

tried the short cable to dish and no switch. Still no quality on odd transponders.Looks like receiver is 1/2 dead.

[Hopey007]

All you can do is try to flash it again, download the file again and start over. What type of lnbs are you using? Have you read the thread on lnbs? Some have switches built in etc etc.

Hopey007

[riverman]

I re-flashed it back to the factory bin.Hooked it up and no quality on any odd transponders.I reflashed it again with the Nagra 2 bin.I am using legacy Lnbs not Dishpro.Just a bad receiver.Have to make do with my 315 channels.

[Hopey007]

If they are dual lnbs, is anything hooked up to the other side? If so unplug it .

Hopey007

[yenz]

this is easy let me guess you either have dish pro or superdish i had the same axact problem you need to convert your sat tp to dishpro doing this you take a channel guide or your own open up channel master its a program you can get in the file section or around the net right mouse click on your sattellights and go to dishpro conversion click on convert to dishpro do this step for both sats 110 and 119 then export it and write it to your digi and you should get all transponders to come in good luck