dreambox ?

[dssdork]

ok i finally got my dreambox i programmed it with the multi boot i installed the service list when i connect up it says no service data so i remembered i didnt program the emu n2camd so i went into dreambox controler and programmed that but i still get same message my question is do i need to be connect to my tv and ineternet at the same time when programming or i can program the flashes and where my computer is or do i need to run a ethernet to the receiver for programming also i did a manuel scan all i get is ch 501 and angelone so im thinking key issues can somene point me towards the right direction by the way it is a dm7020

[vmod32]

I don't have one, but just a guess, the files might not have the new key that just changed yesterday...

[smokeyman]

after reading the newbie guide to these fta, i was a bit confused, so i attached null modem cable along with ethernet to my router, as direct to cpu need crossover to ethernet

i then found someone elses backup of nitro's working image , there are a least 2 diff loaders for these boxs, so you will see buy the extenstion on file which it is for

first one i had was dream up file, so with that said using dream up,
connected to fta ,dream up sees ird fine, i then backed up my original image,
opened nitro image and flashed ird , at this time i attached to tv,
then i set the ip adress again as new image changed it ,
next set my lnbs but still no pick a keys were missing.

i guess i could have asked for some help but since it was only day 1 it was to early to ask for help without doing some reading

at this time i located another image, one with keys it was flash wizard file

using flash wizard i flashed this working file, then also added a channel list ,
with proper lnb settings , whammo tvs working

now once i get this game adapter in the picture key changes will be a simple copy and paste procedure ftp wirelessly will be the cats ass

then all we can hope for is a bit of autoroll

[dssdork]

thank you guys