safi1
11-10-2005, 06:38 AM
Ok Tried this (rom_nosign_digiwave1_VV303ACD_0130(1-1-2-3-255-255-255)_2A0_P2.42.bin)and like to confirm that it works on digiwave 6800
At first if failed to boot and it it displayed ---- after the boot so I thought I had to use JTAG to fix it but I didn't have to
I used the FTLink 3.3.0 and then click on the 4th button (fix receiver with broken softwre)
Then put in the password
skyworth
It uploaded after turning on and off the receiver
Once it comes up another attempt will made to upload the bin again from scratch
Then it should say "Good" and turn off and on again and it works!!
(if it fails again then try to load original DIGIW7000_HW130_v303_p240_0922_EPG_N1_N2_Final.bin and try again)
Go to Menu, System Settings, press red button on remote.
Scroll to NagraVision 2 0101 or 0001 Dish Network on Provider, then go to Key00, press OK and enter the new N2 keys below.
f29874441c6577d817e3e11d894e5345
You have to setup your antenna and stuff and you'll notice some 400 channels already listed
At first if failed to boot and it it displayed ---- after the boot so I thought I had to use JTAG to fix it but I didn't have to
I used the FTLink 3.3.0 and then click on the 4th button (fix receiver with broken softwre)
Then put in the password
skyworth
It uploaded after turning on and off the receiver
Once it comes up another attempt will made to upload the bin again from scratch
Then it should say "Good" and turn off and on again and it works!!
(if it fails again then try to load original DIGIW7000_HW130_v303_p240_0922_EPG_N1_N2_Final.bin and try again)
Go to Menu, System Settings, press red button on remote.
Scroll to NagraVision 2 0101 or 0001 Dish Network on Provider, then go to Key00, press OK and enter the new N2 keys below.
f29874441c6577d817e3e11d894e5345
You have to setup your antenna and stuff and you'll notice some 400 channels already listed