new to fta need some help

[fonzv]

using 3500 pansat dish 500 with org lnb's pansat 1.0 switch dish is aimed properly not which sat's in menu are 110 and 119 tried a few no signal
any suggestion.
I'm assuming dis h is aimed properly becuase have not moved it since I was using a dishnet reciver
Thank you
fonzv

[butthead101]

lyngsat has good info on what you are looking for

[FRESENG]

Fonzy,
Did you flash your receiver with the new bin? Do you have a channel list?

[fonzv]

I did flash no channel list does not appear to have signal strenth

fonzv

[fonzv]

also when I do a blind scan info 0 transponder found?
Fonzv
I did do flash again

[calin]

When you mention the 1.0 switch, do you meant DiSeQc Switch 1.0 or the SW-21? Looks like you have no physical conection betwen your LNBs and your receiver, please double check your instalation, something is broken betwen the dish ante the receiver, or your settings in the receiver are wrong or you fried the switch!!!

[FRESENG]

1) Do U have the new Nagra 2 keys on your bin.

2) Do you see if the signal strenthg is over 64 in both satellites. If not, do the following:

-Get new nagra 2 keys bin,
- Go to menu
- Antena Set up
- Get sat 119, enter Ok ...
LNB=Standard/ Lnb local freq=11250/ 22KH = off/ Disqc= #1/ Skew=0/ TP n2 or better/ possitions settings= Disable/ sat scan= all.(do the same for sat 110 )


Do a SAT scan, first 119 then 110. Now you are set. !!!!enjoy!!!!

(You need DiSeQc for FTA receivers. i do not remember the name of it) Wont work on a sw21.