single tsop 013

[wasup]

I have an 013 i sent to oddcircuits for a lock and vidmod (to use with mc). Now I need to use atmega on it. Do I need to vidmod again to write tsop? Last night I erased and it wont write without error "flash not blank write anyway".
One toggle switch was installed by cardslot, I assume its for lock on/off.
Thanks

[scorpionking]

Vidmod must be active in order to erase or write.

[wasup]

I thought vdmod was to write or erase a certain address, but the rest would write and erase. Guess not. Thank you.

[driveclean]

yes you need your vid mod active to reflash entire tsop after erasing it. I tried and would do 99 percent then error in 7fffff40 section. That section must be the protect write area. You can erase it but not write to it without your vid mod going.

[JCK7]

I think off got 3.54 v on 12 v dc so write to chip test wire in middle blank chip .Flip on have 9 v then write to chip

One toggle switch was installed by cardslot, I assume its for lock on/off.

[wasup]

I think off got 3.54 v on 12 v dc so write to chip test wire in middle blank chip .Flip on have 9 v then write to chip

One toggle switch was installed by cardslot, I assume its for lock on/off.
huh?

[Horseman]

Make sure your oddcircuits lock is off, did the same on my 3900.....