billko
11-24-2005, 09:29 AM
Can't seem to get my 2800 running w/N2, tried several pre-modded bins (at least one with a Build Config very near my own), modded one of my own w/flashedit, made and flashed virgin eeproms each time, changed Build Data to 00 02. Keeping getting the Acquiring Signal nag 15.
On the last attempt, I was able to get into the Installation and Dish Pointing menus. (on previous attempts, the ird would reboot each time I pressed installation). The indicator showed no signal (which would explain the nag 15), although the same dish is working fine w/other irds. In fact, I can flash back to my old firmware and receive the FTA channels, so the box is alive and well, must be a software issue. Ran a Check Switch, no help. Menu is working but running far slower than it did with the old N1 bin.
Any ideas about what to try next? Thanks for any tips!
On the last attempt, I was able to get into the Installation and Dish Pointing menus. (on previous attempts, the ird would reboot each time I pressed installation). The indicator showed no signal (which would explain the nag 15), although the same dish is working fine w/other irds. In fact, I can flash back to my old firmware and receive the FTA channels, so the box is alive and well, must be a software issue. Ran a Check Switch, no help. Menu is working but running far slower than it did with the old N1 bin.
Any ideas about what to try next? Thanks for any tips!