how to update the firmware to latest rev??

[guitartom]

how do i update the 2800 firmware to latest rev?? will it update in the stream without a valid n2 card in it? build is CAPD.

[riverman]

erase SA5 and re-stream or download a modded CAPA file and erase the old file and write the modded file if you are into modding.

[tou xiong]

I'm having the same problem on my 301 13. I need to update the frimware to 208. when i erase SA49 it goes into a power cycle mode for hours. currently i have 207, and it wont work with avrx. all i get is previews.
any suggestions?

[PT2]

Have you done a vid mod on that .013?? If not , you really should do one. Goto the How to guide on this site and they got a great vidmod procedure..

[tou xiong]

Yes i have already vmod the unit. it does the same thing when i try to load 204, then once it is plugged in it goes into the cycle.

[PT2]

Before you goto Flash Program to Erase your sector, did you ground R79??. Also maybe you should do a Full erase and write the p2.07 back. then just let it update in the stream.

[GEEK]

Do you have a digital lock on this 013? If so, you need to disable it or it will continually reboot and never get the update.

[tou xiong]

No digital locks. I can write and erase the firmeware and eeprom completely fine, just that when i try to update the firmware from the stream it goes off and on for hours. i even try letting it sit over night. and same thing happened the next morning

[PT2]

If you erase and write firmware then all you need is a P2.08 bin ,I got 3 different ones from different build cfg. Match one of my build cfgs. DASA, DAMD , DAHD and i will PM you one of the bins if you want.. The only thing is i cannot get them to work with the AVR-X's. I get error 357 and 129 with them... let me know if you want one ...

[tou xiong]

I have a DAIA, but i don't think it would matter. PM me... it's still stuck on 207

[NICKY__6]

does vid mod need to be turned on to update via satellite from 207 to 208

[PT2]

No, the vid mod does not have to be On.