Boy447374
11-26-2005, 07:43 PM
I have a quick question and hope someone can help me out. I modified an old white viper for unlocking A24. I am getting a good mixture of F and 6F about 50-50. The problem is it will not unlockmy Rom 10. I measured voltage from pin 1 of the card slot (VCC) to ground. (Across the impedance matching pot) While the script is running I am getting a good glitching voltage. WHEN THE ROM CARD IS NOT IN THE CARD SLOT the voltage is glitching on-off-on-off-on-off . But when I place the rom card in the slot I am getting a steady 4.9 volts. Changing the pot doesn't do anything to the voltage and neither does changing the voltage settings in the script. Anyone have any ideas what the problem is here? Or is this normal? A constant 4.9 volts after I place the card in but the results are good according to the result window as I'm getting a good combination of 6F and F. Since I am getting good readings with the F and 6F does that automatically mean everything is working properly or could I have a hardware problem? (burnt out chip or component) Please post your opinion or if someone could measure voltage on their unlocker while the script is running to let me know what kind of voltage you're getting with the card both in and out. I'd appreciate the help very very much.