keshka
11-28-2005, 08:22 AM
Hi, any information would be greatly appreciated. I was trying to use "all in one n2 fix" file, followed the"How to.." guide, saved my original TSOP- I used simple non-buffered J-tag with five 100 Om resistors and wires less then 6", made changes in Flashedit and then was going to rewrite new TSOP- as the guide I used http://www.bellexpress.vu/tsoprestore.html, but after trying to"Flash Programming" and using option 2(off-on-OK within 2-3 seconds) I 've got "The flash codes returened are not recognized by J-keys. MF/Device codes returned are FA25/2532(JEDEC) and FA25/2532(Flash File)", if I use option 1(off-ground pin1-on-OK) I'm getting "the same message but no numbers-only FFFF/FFFF(JEDEC) and FFFF/FFFF(Flash File). For grounding pin(pad)1 I used picture from the topic "TSOP Backup", but topic "JTAG HOW TO" has numeration for pins(PADS) in opposite order, and here i'm confused if I used right one for grounding. I still can read memmory with Jkey's, nothing changed. If I put Atmega into IRD - I'm getting Guide from my N1 programming, info channel, Sys info gives me all information and location id is not 00000's. And BTW JKey's gives me "Build conf. CSCA. Boot Strap 15AB. Model ID 11r Soft. 834P. Model 2800. Flash1(29F400). But sticker says COCD. And now I'm confused -to build buffered J-tag?, or I did something wrong?, or maybe settings on computer are wrong- I used 2.4 P4 Xpro+sp2 , LPT portx0378 and even tride old comp with Win98- still the same