PDA

View Full Version : N2 ATM One-stop-shop partial work

turboccc
12-01-2005, 04:08 AM
Hi there,

I did the one-top-shop procedure in the sticky thread on my 3100 and atmega card....

Wow! It boots and I have an image...

Damn! I only have 10 channels from bev (new registration, ...)

any idea?

I only did the steps in pikachule1's thread... I thought it was the simplest...

Regards,

TurboCCC
DB
12-01-2005, 04:15 AM
I think bev is still changing keys.
turboccc
12-01-2005, 05:04 AM
Oups! We have a rusty tester here...

I programmed my bev receiver with Dish firmware (TSOP) and I did not point to a dish satellite. It says wrong satellite. Of course, I point to bev... It's winter here! I am not going on that roof! I'll wait for Spring or a bev fix...

Curiously, it locks but only a couple of useless channels...

Cya!