T911 (Blue) - 'Could not find Active Atmel'

[asajwani]

I have 6 dip switches T911.

I am trying to load the flash newd11 with swtich 1 and 5 ON, as well as I tried switch 1 and 6 ON. All the time I am getting following error.

Hex Files Loaded..
Initializing...
Initializing...
Syncing...
Failed: Could Not find Active Atmel
Completed.

I am using PS/2 to supply power.

Need Help

[STP]

If it's the same blue one I have,try this

1 and 5 on, to flash and the switch between the dips and the power jack, goes towards the power jack.

2 and 5 on, to glitch and the switch between the dips and the power jack, goes towards the dips.

This works for me hope it helps
STP

[asajwani]

Mine T911 is totally covered with Blue cover plastic.
I was unable to find any switch.
Can you please provide me the discription of switch, it is on the top, bottom or side?

thanks for help.

[HILLBILLY]

Mine T911 is totally covered with Blue cover plastic.
I was unable to find any switch.
Can you please provide me the discription of switch, it is on the top, bottom or side?

thanks for help.
there should be some very obvious dip swithes on it. mine are next to the power input and trim pot. never seen one without them. not sure what u have if they are not there?!?!?

[woods]

maybe his t911 has never beed moded?? just has the 6 dip switches? just maybe

woods

[STP]

Maybe woods is right, that it hasn't been modded
Mine is like Hillbilly's it's a small switch between the dip switches and the power input and just slides left to right.

STP

[Cimba]

2 different models being discussed, his is the original T911 but the question remains is it modded ?

[Dsswhiz]

does anyone know the dip switch settings for a modded nexus T911 ......... i just got one form **********............... and what power voltage does the unlockers use??? thanx .......

[HILLBILLY]

does anyone know the dip switch settings for a modded nexus T911 ......... i just got one form **********............... and what power voltage does the unlockers use??? thanx .......
mine is oragne nexus, 1 and 6 to flash, 3 to glitch.
power voltage must be 10v or greater.
hillbilly

[Dsswhiz]

thanx hillbilly ......am gonna see if i can get this baby to work now!! ........ any tip on getting started on unlocking a rom10 with a orange modded nexus t911 would be a greatly appreaciated....

[HILLBILLY]

thanx hillbilly ......am gonna see if i can get this baby to work now!! ........ any tip on getting started on unlocking a rom10 with a orange modded nexus t911 would be a greatly appreaciated....
ok, make sure your trim pot is set at 2.2.
now, READ the how to sticky in this forum. pretty much step by step.
also, what rev is it at now? a23 will go no prob. if its a24, i've had at least 10 of them, for some reason, i could not pop even one of them. less than a23, no need for a modded t911.
i'll help, no problem.
hillbilly

[asajwani]

In mine T911, there are 6 dip switch and another switch(sw1) with 2 small metal lids with plastic connector on both.

I tried flashing using SW1 with plastic connector as well as with out plastic connector with Dip 1 & 5 ON, 1 & 6 ON.

Still getting
'Could not find Active Atmel'

I am using power from PS/2, Should I use external power? i