Black Screen

[Doorguy]

HI I have a 3100.010, reflashed with the all in one instructions, using an atmega 18mhz board.

My ird boots up fine, guide comes in but no audio and video on any channels except Nasa and charlies channels. I have programmed with tomico n2 w /key update. The keys I am using are key 0 f2 98 74 etc.
key 1 17 e3 e1 etc.

If my ird is working like it should , I should have done all that ok, right?

What could be my problem?

thanks

[Doorguy]

If I put on a tsop with congi eaea on my ird and my config is aead, would that make a difference even though everything is working except audio/video?

Thanks

[Stocko]

Try to modify your EEprom build config to DAEA then write it to the IRD. Make sure that you plug the power in on the IRD without the sat cable hooked up for 5 to 10 minutes, then try hooking up the sat cable.

Stocko:cool:

[Morpheux]

That happened to me a couple of days ago, just reprogram the card, that should fix it.

[Chevyguy1998]

Dish 3900 Atmega 128
Same problem right now, black screen, but everything else, guide, and the dish channel, but no others. I have redone the card 3 times with Atmega N2 V10. Any other suggestions? IRD perhaps?

[Morpheux]

try the original tomico flash and eeprom, is working perfectly for me

[bajamba]

try the original tomico flash and eeprom, is working perfectly for me Go find the new Flash edit2.1 beta 4 It Has the best patch for your receiver. And make sure you use a virgin eeprom. You Will Be Watching T.V. Because I Had same Problem With Mine. Now I'm Watching.