joaal
12-05-2005, 02:13 AM
:confused:
something strange is going on with my dish 508.
The story: I saved original tsop 1 and 2 (firmware is p303). Loaded tsop 2 in flahedit-2.1beta4, changed boxkeys and ird number, aplied the new script (501-p3.04) and saved, also saved virgin eeprom. Deleted tsop 1+2 on my receiver and wrote the new tsop2 and virgin eeprom to it.(vidmod on. tsop lock and eeprom lock off) Normal I need to change address 7FFFFFAC from D500 to 0000 but this was already 0000. no problems so far, no errors. loaded atmega with hex.hex an eeprom.eep, changed lock/fuse settings. Powered ird on without cable, waited 3 minutes, in stream, get the error - smartcard not for this receiver-
pulled card out for info screen and showed me the old original ird number. card number was ok. Checked receiver with jkeys and showed the new ird number and boxkeys. Checked new uploaded tsop and eeprom files in hexeditor and found the new ird number and boxkeys. build config in eeprom file is ok.
Did the whole thing a few times over but still the same problem.
Any sugestions?????????
thanks
something strange is going on with my dish 508.
The story: I saved original tsop 1 and 2 (firmware is p303). Loaded tsop 2 in flahedit-2.1beta4, changed boxkeys and ird number, aplied the new script (501-p3.04) and saved, also saved virgin eeprom. Deleted tsop 1+2 on my receiver and wrote the new tsop2 and virgin eeprom to it.(vidmod on. tsop lock and eeprom lock off) Normal I need to change address 7FFFFFAC from D500 to 0000 but this was already 0000. no problems so far, no errors. loaded atmega with hex.hex an eeprom.eep, changed lock/fuse settings. Powered ird on without cable, waited 3 minutes, in stream, get the error - smartcard not for this receiver-
pulled card out for info screen and showed me the old original ird number. card number was ok. Checked receiver with jkeys and showed the new ird number and boxkeys. Checked new uploaded tsop and eeprom files in hexeditor and found the new ird number and boxkeys. build config in eeprom file is ok.
Did the whole thing a few times over but still the same problem.
Any sugestions?????????
thanks