Dish 3900 Cycles On and Off

[Chevyguy1998]

Dish 3900, Atmega 128. Followed the All in one fix to the letter, but when I plug in the receiver, it cycles itself on and off, and I don't have any control of it. I try to turn it on with the remote but it does nothing... Any Ideas? Thanks!

[woods]

does it do that with the card out? if so sounds like a corrupt tsop.

woods

[udntcme]

How much on/off one time on/off/on can be normal do you watch it go on/off a bunch of time's...? sounds like a corrupt tsop if it does this ......

[Chevyguy1998]

It also does it with the card out. I have no control of the receiver with the remote. The remote is fine, it worked 1/2 hour before that. But it still turns on and off on it's own... Can the eeprom be a problem? I mistakenly put a different eeprom on too.. the Files I used had one for Tsop and one for Eeprom

[Chevyguy1998]

goes on and off every couple of minutes

[udntcme]

Ya ,you need to put the correct eep with the tsop.When in flasedit You can just ckick "apply script" to create a "virgin eep" It may ask you to enter your build config.