new t911 mod

[darkmoon]

thought my older loder was fried so got new one T911 blue case ,green board)from ********** . this one has a trim pot ,but different from the old one .this one has a sw1 switch , For what?
HAven.t been able to get a reading for adjusting the pot.
tried a card with sw1 switch at both settings & all I can get is
Trying to reset the card
Reset Failed!!!

Any sugestions?
darkmoon

[Cimba]

Usually a switch is installed for flashing purposes. In the on position you can flash but not glitch and of course the opposite is true when the switch is off, you will have to determine which way is what. Also you must set your dip switches to match what you are doing as well, usually 1&5 to flash and 2&5 to glitch. Unfortunately there were some variations on the modding too so good luck & keep trying.
Reading Crazy's how-to guide is helpfull as well.

[LittleE]

Where can one buy a mod loader......had one but cant seem to find it....Is there a site that sells them mod already

[yahoo]

thought my older loder was fried so got new one T911 blue case ,green board)from ********** . this one has a trim pot ,but different from the old one .this one has a sw1 switch , For what?
HAven.t been able to get a reading for adjusting the pot.
tried a card with sw1 switch at both settings & all I can get is
Trying to reset the card
Reset Failed!!!

Any sugestions?
darkmoon

I just got the same one it looks like the new nexus unlocker I am playing with it also

[kelowna_pitboy]

i have the same one, green board, translucent dark blue case. I can not find the mod however, i have found some drawings that have similar ciruits. where are the exact mod drawings for this combination. i have searched for hours with no luck.

kb

[yahoo]

i have the same one, green board, translucent dark blue case. I can not find the mod however, i have found some drawings that have similar ciruits. where are the exact mod drawings for this combination. i have searched for hours with no luck.

kb

It's already modded I just popped my first rom10 a81 works great

[kiutie]

Hy yahoo, can you tell me where you got the 911?
PM please.
Thank's

[Jani]

Hi Guys,

I need some help, can the MIKOBU 3 be modified to use as a glitcher.
If it can, would you please let me know where can I found it.
I also have a ABSOLUTE 1, same question.

Thanks, Jani....

[Cimba]

Look in the Sticky titled Loader Mods for both.

[Jani]

Thanks, Cimba...

Jani...

[cester]

I have the same one blue case and green board but this has a switch form 1 to 5 plus has a jumper on and I having a lot of trouble with it I have open only one 102 rev 103 and since then I can't not open any more I get this -----++++plus no resp all way to the end of the programm and nothing is happening with dip switch 1 but I don't know about the jumper, I been reading about this trimmer I don't see any screws on the board to adjust this any help is appreciated