Need help

[newfy]

Did a lot of reading tonight, still a little confused.
I have 2700, I have boxkeys, AVR3 and would like to EMU.
AVR3 is OK, but I need to change program, is this right ?
I don't understand about tsop, I have to change it ?
I use cemu for dos ?
What is current version of each ?

[Boris279]

hi newfy,

do some reading on the forums, use your <SEARCH> buton and most of your questions will be awnsers,
first try to find it out by your self, before you start asking, because most questions you aske are allready awnsers .

Goodluck
Boris279

[himeros]

Did a lot of reading tonight, still a little confused.
I have 2700, I have boxkeys, AVR3 and would like to EMU.
AVR3 is OK, but I need to change program, is this right ?
I don't understand about tsop, I have to change it ?
I use cemu for dos ?
What is current version of each ?

A push in the right direction. Look in the Tsop bank for one that matches the build of your computer, find one that is already modified for you. the first three numbers must match your build, such as. If you have a coca you should be able to use any build that starts with coc. You will need to make a virgin eeprom, erase and reflash the new tsop and virgin eeprom to your 2700. Of course you will need a Jtag to do this with. I don't know about your avr3 for emu, as I use the max/mel board, but I would assume you will have to flash it to work with N2. Good luck

Himeros

[BiggerBear]

himeros - Did you get your setup going?
I don't think the Build is a big deal with the 2700/2800. I have used the same Moded Flash on a couple different Builds and they have worked.