help vortecpro 7700

[boricua]

need help how to fix my reciever after trying to write channel master project. now the picture on the reciever is doing something like a wave. its moving up and down non stop. should i put the factory flash and then try to program it? help please...

[calin]

I supposed you did not move the back switch (Channel 3 - Channel 4). I do not know that receiver, but maybe your menu gives you a setting betwen PAL and NTSC, so change it to NTSC.

[puzzlepad]

need help how to fix my reciever after trying to write channel master project. now the picture on the reciever is doing something like a wave. its moving up and down non stop. should i put the factory flash and then try to program it? help please...
First go to hXXp://www.maestra.tv/keys[XX to tt] for the latest keys. Go to hXXp://www.pantecf2a.com[XX to tt] to get Pansat/Pantec v257v4.0 flash and Megasat_BinUploader v2.0. Vortex Pro 7700 is basically Megasat YT6688 receiver but it has a 2MB chip. Set remote in Pansat mode by pressing power button and P button together several times while pointing remote to the ird. Also at the pantecf2a site, download and read pdf's: TIP: Stuck on "Bad or Scrambled Channel" after loading v256x? and TIP: How to update n2 keys manually. These pdfs are located third lines below the Pansat/Pantec v257v4.0 Clone Patch line. After loading new keys; perform a blind scan scanning all transponders. Never load channel lists unto any Pansat 2500A clones like Pantec, Megasat, and Vortex Pro irds.

[boricua]

thank you i will try