Also stuck at Acquiring SAT signal....

[rubberman]

IRD is 3900. running DOScemu with 1 chip emu board flashed with the 1chip 007 hex.

system info shows:
-shows correct IRD number
-all 0's for camID
-dish500 ready is DNASP101 rev007
-firmware is P236 CLFA
-bootstrap is 12CBCLFA
-location ID is NOT 1

its stuck at acquiring sat signal screen. and yes i did a switch test and do have signal on both 119/110 birds. so is it the TSOP?

[FireNeg]

You might want to check your eeprom I had the same problem ans for me on the first line of build data in flashedit advance tab the last 4 digit were 01 02 and I fixed it by changing it to 00 02, save eeprom and reflash, that did it for me

[beaver6]

Are you getting any signal on any transponders on the signal strength meter on either sat ????

[rubberman]

yes i get signal on the transponder screen. well i opend the tsop in the flashedit and it did show 01 02 in the 1st line so i changed it to 00 02 then saved and exited. i wrote it back with jkeys and it wont power on. the light will come on for a few seconds when inserting the dummy card. any ideas???

[rubberman]

are we talking tsop or eeprom? I could open the eeprom image in flashedit only the tsop image