Jkey Error

[Bino]

In Jkeys after I save the memory, at the next step to erase the TSOP in flash programming I get the following error: The flash codes returned are not recognized by JKEYS. Mfg/Device code returned are FFFFFFFF/FFFFFFFF(JEDEC) and FFFFFFFF/FFFFFFFF(Flashfile). Because of this message I cannot continue with erasing TSOP. Can someone tell me how or where to get the information to correct this problem

[0zone]

In flash programming what flash you erase 22 or 23 you should always erase flash 23 first 3 times without removing jtag first program flash 23 then move to 22 in your case jtag move or some thing!


oz

[Bino]

I get the same error no matter what I try to erase. I am using jkeys2_9_11, is this the latest? I must also mention I am using a different desktop computer, the computer I usually work with is down and I never got that error message with it. Can this computer be the problem?
In flash programming what flash you erase 22 or 23 you should always erase flash 23 first 3 times without removing jtag first program flash 23 then move to 22 in your case jtag move or some thing!


oz

[mdfsandman]

I had trouble with one computer erasing a flash- switched comp. and got it. You could also try using "wall" to erase it and reflash

[Bino]

The computer I am using now has Intel PentiumIII, 451 MHz processor and 192 MB RAM, could that be my problem?
I had trouble with one computer erasing a flash- switched comp. and got it. You could also try using "wall" to erase it and reflash

[rez_rez]

no, use wall, and let it restream to update itself