A dead 301.10

[ghost1412]

Need to wake up my 301.10 as it is dead after I earse my both TSOp U22 and U23 , I kept trying now for over 3 hours with no sucess any hint please

[tv2k]

i woke up many 301-10 using wall, just follow the read me file, you should be able to do it

[ghost1412]

Did you load the full U23 first or you only load the first 6000 Bytes ? and witch version of wall did you use ?

[ghost1412]

Every time I try to earse the Flash using Wall 2.2 it freeze and I would hav eto open Jkey and close it in order to make Wall work fine
I do load the boot sector by using U23 the first 6000 and when I unplug the power I should get a light on and then off but in my case nothing happend at all so what am I doing worng ? I start getting fed up from this 301.10

[deolav]

try using another computor

[tv2k]

wall does freezup every now and then, try to write boot sector first them the while flash. If wall freezed, close it down then open it back up do the flash erase then write again. it is common wall does freeze. Keep trying you will wake it up

[tv2k]

Every time I try to earse the Flash using Wall 2.2 it freeze and I would hav eto open Jkey and close it in order to make Wall work fine
I do load the boot sector by using U23 the first 6000 and when I unplug the power I should get a light on and then off but in my case nothing happend at all so what am I doing worng ? I start getting fed up from this 301.10

boot sector still corrupted, that is why it dont light on for you. always open jkey than wall, erase first then write boot sector. then whole flash

[blueman1955]

I have the same problem , i read you had to load 60000 to the boot sector , i still get NO green light, but i hooked the unit up wrong to the Jtag, the instructions i downloaded showed the wrong Jtag hook up , i have it right now I'm wondering if i have damaged the unit its a 3100-10 daul tsop.
Wall will read the Flash and write the flash ,it shows the good box keys but when i use Jkeys all the data that i wrote with Wall 2.2 is not there and Jkeys will not let me Flash says invaliad keys ??

Is there any ideas out there how to fix this ????

[fizzle14]

I had the same problem, here is what i did...

open wall and erase each chip 2-3 times.
Unplug ird for 1 min then plug back in
using wall again, on slow programming write u23 back
unplug ird for 1 min again, plug back in
using wall write u22 and eprom.

This worked for me after fighting with my 301.10 for about a week

[sugadaddy]

Send it to me hehehehehe I haven't seen a single one I cant get to come to life yet.