switch near trim pot

[Pyotr]

Hey all,
Trying to pop a 101 007. I'm getting a good mix of +- and 12FF so far,but it hasn't popped yet. Patience I know.But,my loader has a trim pot that 1)can't get it to turn and 2)there's a switch right above it that has only two settings,right and left. Does anyone know what this switch does? I got the loader frome someone who doesn't know either. Thanks

[yordan40]

Hey all,
Trying to pop a 101 007. I'm getting a good mix of +- and 12FF so far,but it hasn't popped yet. Patience I know.But,my loader has a trim pot that 1)can't get it to turn and 2)there's a switch right above it that has only two settings,right and left. Does anyone know what this switch does? I got the loader frome someone who doesn't know either. Thanks

I think the switch about you trimmer if for flash your atmel chip for unlocking rom 10's use newd6 or newd9 and for 102's use newd13. Switch to your right for flashing and the left for unlock. If you have problem flashing the atmel chip adjust the dip points until you get it.

[Pyotr]

Didn't have any trouble flashing to newd11. Wish I knew for sure what that switch does. Anyway,I'm getting good 12FF responses and the damn 101 won't pop.

[Cimba]

With the T911 at least, the switch is on for flashing the unit and off for unlocking as posted above.

[Pyotr]

With the T911 at least, the switch is on for flashing the unit and off for unlocking as posted above.

Okay.Makes sense.But,is that only for ROM10's?I suppose left is off and right is on?Thanks guys,I never had a modded l.oader before and the guy who gave it to me didn't know either.

[BirdieMod]

After the mod the switch is left always off except to reflash the atmel chip on the loader.