ROM102_ND13_A0FF-INTERCEPT-autoVCC_20_Smart.xvb - where is it?

[kelowna_pitboy]

i can not find it in the downloads. the only copy i have is

ROM102_ND13_A0FF-INTERCEPT-autoVCC_20.xvb

mine is missing the smart part in the file name. my current glitching situation is i keep getting the statement that the glitching is beginning but all i get is the no atr is received and no 2nd atr is received etc.....

i am using a rom 102 rev 103 and i have 2 cards and both are acting identical. i have used between 1 ohm to 10,000 ohms. i can make the error message slow down but i can not get the +-+- stuff that i assume i am looking for.

any help appreciated.

kb

[ellsmako]

What voltage are you using, I found that 7.2 is pleanty, you are using an iso programmer and winexplorer 5.x . the smart on has an added sound file.

you can get it in the down loads under 10x files or over at hashhu.

[kelowna_pitboy]

my t911 uses a 9 volt power supply. the t911 ciruit has a 5 volt regulator so why would changing the voltage make any dif? did the hardware mod to the loader bypass the regulator?

thanks

kb

[Pyotr]

my t911 uses a 9 volt power supply. the t911 ciruit has a 5 volt regulator so why would changing the voltage make any dif? did the hardware mod to the loader bypass the regulator?
thanks
kb

I'm using a pre-modded t911 with a variable PS. raising or lowering voltage can make a difference.If i set voltage to say 7.5v the script slows down or errors out and shows more XX's raise it to 12v and it flies and shows more 12's. Pretty sure most t911's have regulators too.

[kelowna_pitboy]

can someone explain how a modded t911 makes any difference by changing the power supply voltage? a regulator regulates the voltage to 5v, as long as there is 6 volts or more.

kb

[kelowna_pitboy]

i have moved this discussion to a new thread callefd t911 power settings - help.

thanks for everyones help to this point

[Wyatt Earp]

just a quick tip.... if you can't get anything except NO ATR and NO 2nd ATR.... then try removing your POT.... then run script and see if you now get ---------------- if you do then you need to keep looking at why your pot is not correct...

i ended up using a very small pot with less then 1k ohm resistance to get mine to work.. my cards pop right around 25 ohms.... in fact i see most cards pop right around 20 to 60 ohms... so why the 5k pot is suggested i have no idea ??

good luck

[kelowna_pitboy]

ok when i remove pot, i get the error message box to flash with newd13.hex i did that twice now without errors. what are the exact bytes of the proper file and i will see if that is it.

kb