Model 6000

[brad22773]

I have a 6000 I am trying to fix for a friend.....

I downloaded a modded tsop I thought was for the 102 to 10 and it was a CNAA build....the build for mine is a CNCD. I backed up the originals and erased Flash 1 and the wrote the new flash 1 tsop. then erased flash 2 and wrote flash 2 and then the virgin eeprom. After everything wrote I noticed that jkeys didnt detect the ird,boxkeys, build config, or software revision. I tried to erase it and write the original back and now jkeys gives me the DCU control register error and I cannot erase it......any ideas would be greatly appreciated.

[fubr]

When did you flash the eprom with a virgin for your build?
sounds like you flashed flash 2 inot flash 1 or unplugged the ird before finshing.you may have lost control over the cpu and will have to try doing the bfl ground and maybe get it back so you can flash it correctly

[brad22773]

ok....I unplugged it from power for about 5 minutes and it recognized everything.....apparently these babies are a little picky...LOL

[brad22773]

OK...can someone tell me how to make a modded tsop for a 6000 for the ROM102 to Rom10

[fubr]

download the one that is already modded from the files page.
make a virgin eprom and then flash the virgin and then flash the modded tsop to the ird.
thats it.