301, 1-chip cemu, key question.

[basketcase]

I've been using plastic a while and jsut dived into emu. Setup a 2313, 1-chip cemu in the same receiver plastic was working in. I finally got the emu working to the point of aquiring sig, dloading guide and audio/visual on channel 100 but other channels black. Am assuming this is becuase of needing to update the keys. I have read over the other posts on updating keys, but it is just not jiving for me.

Some say use nagra, others say thats bad. Some say you can put them in the ini, some say that doesn't work. When I open my dish.bin (the one from the working cemu setup) there are no numbers on or any where around line d860. I've tried putting in keys I've attained from KeyRipper in anyways beginning at the 4th set i believe it is, but it just breaks the emu from even running. I've tried placing them in keys.ini, no love, been told that isn't even used anyway yet, it's just there to be perty. So anyway, can someone just layout where and in what format these keys need to be placed and then how and where to save and update them, I'm sure others have the same question and we'd all love you long time for helping. :)

Many thanks and blessings.

[cancom]

In Nagra load DISH.BIN as a ROM10
Key86 is at ($D863)
Key96 is at ($D873)

D860: 01 01 00 0F EC B7 55 17 14 59 AB B6 94 39 4E 5C
D870: E2 66 38 FB D9 F2 D9 D6 C9 EF 7A 57 AD 32 24 67
D880: 42 6C E6 00 00 00 01 01 00 AB C5 7C FA 14 C4 14

In this case....
Key86 would be: 0F EC B7 55 17 14 59 AB B6 94 39 4E 5C E2 66 38
Key96 would be: FB D9 F2 D9 D6 C9 EF 7A 57 AD 32 24 67 42 6C E6

Not sure if Keyripper has been updated for N2 10 hex digit keys.