Nexus Mod. T911 fails FLASH verification???

[tobyguy]

Hi All,

I've tried flashing my Nexus Modded T911.

This is a factory mod. I've tried 2 of them on 3 different computers, using

ufp18, ufp16, XP Flasher, XpAtmel_2, and can't get either of them to work.

Both have the same issues.

ufp16/18 always says NO AVR.

XPATMEL starts to program, but FAILS the verification, see below.

Hex Files Loaded.
Initializing ...
Initialized
Syncing ...
Synchronized
Vendor Code: 1e (Atmel)
Part Family: 91 AT90S2313
Issuing Chip Erase ...
Erased
Vendor Code: 1e (Atmel)
Part Family: 91 AT90S2313
Programming EEPROM ...
Programming Flash ...
Verifying EEPROM ...
Error verifying EEPROM: Addr 0006,
expected 00, found ff
Stopped on failure
Complete!


Anyone know what's wrong?? Should I ignore that it fails the verification???

Thanks,

Tobyguy

[smithers]

had the same issue. I found that if I turned the unit off for a while, let all the heat disapate from the unit, it was more likely to take a full correct flash. Use xp atmel.