Blue rom10 @ rev A24 stream locked

[fulldish]

Hello , I need some help , i have a rom10 @A24 stream locked , i have iso programer and T911 modded , i need to know the procedures and the right scrypt to be used to unlock this card.

I getting this screen and tryed everything, pot adjust , another scrypt, and only get reset failed.
Thanks
Reset Failed!
Executing Script: C:\DISH FILES\UNLOCKERS\A24UNLOCKER\A24UNLOCKER\wwwA24-StreamORchecksumlocked fast .xvb
Trying to reset card...
Reset Failed!
Executing Script: C:\DISH FILES\UNLOCKERS\A24UNLOCKER\A24UNLOCKER\wwwA24-StreamORchecksumlocked fast .xvb
Trying to reset card...
Reset Failed!

[#40Fan]

Make sure that you are using the Loader 2 settings. Search for them if you don't know what they are.

[Devo]

Also download XP Atmel 2.1 has all the flashes

[Mezlo]

This script automatically sets up your winex settings, just set config to unlooper. Dish rom 10 any rev, STREAMLOCKED And Dealerlocked! Modded by DrSagan

rom10unlock_new_b found at another site (rom10x)
hxxp://www.rom10x.com/forums/showpost.php?p=94284&postcount=38

Set your pot to 1k like in script instructions and let the VccAnalyzer run, it will give you the floor and ceiling. Plug those numbers into the script and let it run.
I had an A24 that i let different scripts run for 10 hours and nothing. I used this setup and in under 3 mins the A24 was open.

All credit given to DrSagan...

[BirdieMod]

Powersync 3 make sure to run the vcc anaylize. For A24 the A23 script works just lower the start delay setting to about 1180 hex. Most pop around 1189 to 11c0 delay.
Make sure to setup winex program parameters for powersync.

[JT]

Also check the basics. Make sure your plugged into the right port etc.

[BirdieMod]

Yep, I almost posted to make sure card is in right also, Seen cards upside down etc too. Kinda assumed that wasn't the case here though.